BLACK LINE HONEY WELL 90° QUARTZ BANGER BY HONEYBEE HERB

To properly use the Honey Well, you will place the smallest pearl of the marble set in followed by the second largest, or valve marble, which will fit into the middle chamber. Heat appropriately with a butane torch. When finished heating allow the nail to cool to your desired heat, then place your product into the bottom chamber and top with the largest marble. Once the camber is sealed, the air that is pulled through the angled holes in the side of the bottom chamber will cause a vortex to spin the pearl in the bottom while also rotating the valve marble. The valve marble helps keep product from reaching the upper chamber of the quartz banger.

This is the unit design comes in both 45-degree and 90-degree and is available in male and female connector joints ranging from 10mm, 14mm, and 18mm.

FEATURES:

• Full Weld
  
• Edge: Bevel
  
• All-In-One Frosted Joint
  
• Two Auto-Spinner Side Holes
  
• Bucket Thickness: 2mm Bucket
  
• Outer Diameter: 20mm
  
• Bucket Height: 60mm
  
• Bent Degree: 90 Degrees